|
Description: The 2004 edition of this comprehensive detailing manual provides answers to many questions from design engineers, architects, contractors, detailers, and engineering students. It is divided into three sections including “Details and Detailing of Concrete Reinforcement (ACI 315-99),” “Manual of Engineering and Placing Drawings for Reinforced Concrete Structures (ACI 315R-04),” and supporting reference data. Section 1 defines responsibilities for architects, engineers, and detailers and establishes standards of practice for both structural and placing drawings. Section 2 illustrates methods for presenting necessary design information through 50 oversized, fold-out (11x17) drawings of highway and non-highway structures. Structural drawings conform to “Building Code Requirements for Structural Concrete (ACI 318-02/318R-02)” and all drawings were prepared with the assistance of the Federal Highway Administration, California Department of Transportation, and Concrete Reinforcing Steel Institute. Supporting reference data in Section 3 includes specific chapters on reinforcing bars, wires, bar supports, spirals, mathematical formulas and tables, and common symbols and abbreviations. Published by ACI.
Contents:
DETAILS AND DETAILING OF CONCRETE REINFORCEMENT (ACI 315-99)
PART A - RESPONSIBILITIES OF THE ARCHITECT/ENGINEER
Chapter 1--Structural Drawings, p. 315-2
1.1--General
1.2--Drawing Standards
1.3--Structural Drawings--Buildings and Other Structures
1.4--Structural Drawings--Highway and Transportation
Chapter 2--Standards of Practice, p. 315-3
2.1--General
2.2--Tolerances
2.3--Bar Lengths
2.4--Hooks and Bends
2.5--Beams and Girders
2.6--Columns
2.7--Development and Splices of Reinforcing Steel
2.8--Joint Details
2.9--Reinforcing Steel Supports
2.10--Special Details for Seismic Design of Frames, Joints, Walls, Diaphragms, and Two-Way Slabs
2.11--Corrosion-Resistant Coatings for Reinforcing Steel
PART B - RESPONSIBILITIES OF THE DETAILER
Chapter 3--Placing Drawings, p. 315-10
3.1--Definition
3.2--Scope
3.3--Procedure
3.4--Drawing Standards
3.5--Building Drawings
3.6--Highway Drawings
3.7--Detailing to Fabricating Standards
Chapter 4--Fabricating Practice Standards, p. 315-15
4.1--Fabrication
4.2--Extras
4.3--Tolerances
Chapter 5--Supports for Reinforcing Steel, p. 315-16
5.1--General
5.2--Types of Bar Supports
5.3--Side Form Spacers and Beam Bolsters
5.4--Placing Reinforcing Steel Supports
Chapter 6--Computer-Assisted Detailing, p. 315-16
6.1--Use of Computers in Detailing
6.2--Placing Drawings
6.3--Ordering Procedures
Chapter 7--Recommended Practices for Location of Bars Designated Only by Size/Spacing, p. 315-17
Chapter 8--Glossary, p. 315-17
Chapter 9--References, p. 315-18
9.1--Reference Standards
9.2--Cited References
MANUAL OF STRUCTURAL AND PLACING DRAWINGS FOR REINFORCED CONCRETE STRUCTURES (ACI 315R-04)
SUPPORTING REFERENCE DATA
1. REINFORCING BARS
2. WELDED WIRE FABRIC
3. BAR SUPPORTS
4. DATA FOR METRIC REINFORCEMENT AND METRIC CONVERSION FACTORS
5. COMMON SYMBOLS AND ABBREVIATIONS
6. REFERENCES AND DATA SOURCES
INDEX
|